Quantum DLT-V4 Betriebsanweisung
Chapter 5 Installing the Tabletop SCSI Tape Drive
Connecting the SCSI Interface Cables
DLT-V4 Product Manual
38
Figure 19 SCSI ID Selector
Switch
Switch
Connecting the SCSI Interface Cables
5
In the final installation stage, you connect the SCSI and power cables to
the tape drive.
To connect the SCSI and power cables to the tape drive, follow these
To connect the SCSI and power cables to the tape drive, follow these
steps:
1
Shut down the operating system and power down the server or
workstation.
2
Power off all peripheral devices, such as printers and other SCSI
devices.
3
Obtain a SCSI cable with an open 68-pin, high-density connector.
4
Connect one end of the SCSI cable to one of the connectors on the rear
panel of the tape drive as shown in
. Either SCSI connector
works equally well.
does not show a terminator because
none of the three tape drives in the illustration are at the end of the
SCSI bus.
Caution:
Do not go to step 3 until you have completed steps 1
and 2. Failure to follow these instructions may result
in damage to the tape drive or other devices.
Press here to decrease
SCSI ID
Press here to increase
SCSI ID