Quantum LTO-2 Installationsanweisungen
8
Manually Removing an LTO Cartridge
Figure 7. Worm Gear
14.
Continue turning the worm gear until the cartridge is sticking out of the unit approximately 17 mm
(0.66”). Then carefully pull the cartridge out by hand.
15.
After removing the cartridge, put the top cover back on the drive; then replace and tighten the screws.
16.
Return the drive to Certance.
If you have any questions about this procedure, contact Technical Support.
CAUTION: Do NOT use the drive after you have removed a cartridge. The drive must be returned to
Certance for servicing.
Certance for servicing.
NOTE: Any tape cartridge removed using this procedure should be retensioned before it is used for
reading or writing data.
reading or writing data.
Copyright © 2004 by Certance LLC. All Rights Reserved.
May 2004
Certance and the Certance logo are trademarks of Certance LLC. Other product names are trademarks or registered trademarks of
their respective owners.
Certance reserves the right to change, without notice, product offerings or specifications. No part of this publication may be
reproduced in any form without written permission from Certance LLC.
Certance provides this document “as is,” without warranty of any kind, either expressed or implied, including, but not limited to, the
implied warranties of merchantability and fitness for a particular purpose. Certance reserves the right to change, without notification,
the specifications contained in this manual. Certance assumes no responsibility for the accuracy, completeness, sufficiency, or
usefulness of this manual, nor for any problem that might arise from the use of the information in this manual.
May 2004
Certance and the Certance logo are trademarks of Certance LLC. Other product names are trademarks or registered trademarks of
their respective owners.
Certance reserves the right to change, without notice, product offerings or specifications. No part of this publication may be
reproduced in any form without written permission from Certance LLC.
Certance provides this document “as is,” without warranty of any kind, either expressed or implied, including, but not limited to, the
implied warranties of merchantability and fitness for a particular purpose. Certance reserves the right to change, without notification,
the specifications contained in this manual. Certance assumes no responsibility for the accuracy, completeness, sufficiency, or
usefulness of this manual, nor for any problem that might arise from the use of the information in this manual.