Quantum scalar 1000 Betriebsanweisung

The installation checklist has instructions on how to install the SNC 5100 with 
SCSI attached storage and Fibre Channel attached hosts. 

 5

Label both ends of each SCSI cable 
with:
° Drive ID and SNC 5100 connector 
number

None.

 6

If you are using the ADIC 
Management Console to manage the 
SNC 5100, configure an Ethernet 
environment. Decide on network 
parameters:
Ethernet port configuration decisions:
Static IP address____________
Netmask (if required)_________
User-defined SNC 5100 name 
(optional)__________________

You may need to assign a default 
network gateway address and/or route 
table entries:
________________________
Caution: Save this configuration 
information for future reference.

For more information, see the ADIC 
Management Console User Guide.

Obtain the network parameters from 
your network administrator.

Caution: Use of incorrect network 
parameters can cause problems on the 
Ethernet network. 

The default network name is the unit’s 
serial number. If you choose a different 
name, it becomes the prompt displayed 
on the service terminal. Choosing a 
different name may be useful if you have 
more than one SNC 5100. To change the 
name, use the 

 7

If you are using the ADIC 
Management Console to manage the 
SNC 5100, run the Ethernet cable 
from the server (the computer that is 
designated to run the management 
software’s Server) to the network hub.

For more information, see the ADIC 
Management Console User Guide.

 1

Acquire information for Ethernet 
installation.

Refer to Step 6 in Table 2: Pre-Installation 
Checklist.