Champion pp-3 Benutzerhandbuch

C O N T R O L   P A N E L S  
 

The Auto drain/fill feature is an optional feature and requires extra solenoid valves.  Once 
the Auto-Drain/Fill key is accepted, the following sequence of events occurs: 

¾  The unit decides if there really is water in the wash tank (using Dry-Fire detection 

feature). 

¾  If needed, the Drain solenoid valve is activated for the pre-programmed Drain Time 

delay. 

¾  The Drain solenoid is turned off, and the Fill solenoid turned on, for the Fill Time 

delay. 

¾  The Fill solenoid is finally turned off, and all appropriate internal timers and statistics 

are updated (because the unit has a fresh load of water). 

 

During the drain portion of the sequence, the unit displays A U T O - D R A I N .  In the fill 
portion, the unit shows A U T O - F I L L . 

This is an optional feature and may not be equipped on your system. When the unit is in the 
OFF state or Change Water mode, keeping the OFF key pressed for 2 seconds will force a 
Manual Drain.  This turns on the Drain solenoid valve for Drain Time delay, after which the 
unit goes into Power-Up mode.  This is used at the end of the day, when the user turns off 
the unit and empties the wash tank.  During the Drain, the display scrolls D R A I N I N G . 

The sanitizing tank is optional on the appliance.  This is a tank that is usually used to sanitize 
the cookware after it has been washed.  This tank can have its own optional soap pump, as 
well as an optional heating element.  Its Drain valve is wired in parallel to the wash tank 
valve.  

Diagnostics 

This section describes the various diagnostics errors that are available.  Should one of these 
errors appear, the corresponding error message scrolls on the first line.  All error messages 
have the following text appended to it: -   C A L L   S T   L O U I S   S T A I N L E S S   8 8 8 -

5 0 7 - 1 5 7 8   F O R   S E R V I C E .

  

: Your display may be different. 

35