Champion sd-10 Техническое Руководство

Seite von 4
Pot, Pan And
Utensil Washer
SD-10
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
Champion Industries, Inc., P. O. Box 4149, Winston-Salem, NC 27115 • 336/661-1556 • Fax: 336/661-1979 • www.championindustries.com
SPECIFICATIONS
Machine Construction
12, 14, & 16 gauge Stainless steel.
Heliarc welded seams.
Door
Stainless Steel, split door design. Top half
rises, lower folds down to load/unload table.
Rotating Wash, Hub &
Spray Arm Assembly
Water driven, STAINLESS STEEL spray 
arm assembly with STAINLESS Steel
jets, removable end caps and hand
operated quick release mechanism for
easy cleaning and reassembly. Mounted 
on STAINLESS STEEL base.
Filter
Perforated, removable, Stainless Steel
basket.
Water Pump
5 H.P., 208/240 or 440/480 volt, 1 phase
or 3 phase, 60 cycle with output of 100
g.p.m. at 35 to 45 P.S.I.
Digital Control & Information
Center 
110 volt control circuit, push pad operation
“Power On”, “Stop” and “Short, Medium,
or Long Wash Cycles”. Digital display
indicates “Time Remaining” for cycle. LED’s
indicate wash, rinse & unload functions.
Buzzer provides indication to unload. A
pre-programmed circuit board controller
allows push pad to be used as a “Diagnostic
Center”. Displays “Error Codes” for
troubleshooting.
Gauges
Wash temperature, rinse temperature,
wash jet pressure. Special moisture
resistant design.
Wash Tank
Stainless Steel with electric, infrared 
gas, steam or steam coil heating,
thermostatically controlled, low water
protected, sloped to drain with a 
25-gallon capacity.
Rinse Tank
Stainless Steel with electric, infrared gas
or steam coil booster heater provides
180°/190° hot sanitizing rinse.
Racks
Stainless Steel rod, built to match specific
washing requirements.
SD-10 UTENSIL WASHER