Sony rdr-gx120 Betriebsanweisung

Seite von 88
75
A
d
d
iti
o
n
a
l I
n
fo
rm
a
tio
n
The clock has stopped.
, Set the clock again (page 60).
, The clock stopped due to a power failure 
that lasted for more than 1 hour. Reset the 
clock (page 60).
The TIMER REC indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc inside the recorder.
The recording mode indication is 
incorrect.
, When the recording is less than ten minutes, 
or if a picture with little movement is 
displayed for more than ten minutes, the 
recording mode indication may be 
displayed incorrectly. Note that the actual 
recording itself was correctly made in the 
selected recording mode.
, After playing titles recorded in EP and SLP 
mode, the recording mode indication may 
change depending on the recorded 
programme.
The clock does not appear in the front 
panel display when the recorder is turned 
off.
, “Dimmer” in the “Others” setup is set to 
“Save Power” (page 69).
The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote’s manufacturer code returned to 
the default setting when you replaced the 
batteries. Reset the code (page 15).
, The remote is not pointed at the remote 
sensor on the recorder.
, Different command modes are set for the 
recorder and remote. Set the same 
command mode (page 16). The default 
command mode setting for this recorder and 
the supplied remote is DVD3.
, Press x (stop) on the unit while the 
recorder is turned off to check the current 
command mode.
The recorder does not operate properly.
, Restart the recorder. Press down [/1 on the 
recorder for more than ten seconds until 
“WELCOME” appears in the front panel 
display.
, When static electricity, etc., causes the 
recorder to operate abnormally, turn off the 
recorder and wait until the clock appears in 
the front panel display. Then, unplug the 
recorder and after leaving it off for a while, 
plug it in again.
Five numbers or letters are displayed in 
the front panel display.
, The self-diagnosis function was activated 
(see the table on page 76).
The disc tray does not open after you press 
Z
 (open/close).
, It may take a few seconds for the disc tray 
to open after you have recorded or edited a 
DVD. This is because the recorder is adding 
disc data to the disc.
The disc tray does not open and 
“LOCKED” appears in the front panel 
display.
, The disc tray is locked. Cancel the Child 
The disc tray does not open and “TRAY 
LOCKED” appears in the front panel 
display.
, Contact your Sony dealer or local 
authorized Sony service facility.
Display
Remote control
Others
,continued