Brady BP-IP300 Betriebsanweisung

Control Panel

Press the menu key.

Select Setup > Print param.

Heating value to compensate for different 
thermal behavior of printheads. Changing 
this value is necessary if the printing intensity 
has changed after replacing the printhead.
To adapt the printing intensity when using 
different media, print speeds or printing 
contents, you should change the heat level in 
the software. The settings from the Print 
param.

 menu and the software are added 

together.
The heat level setting also affects the test 
printouts.

0

Basic print speed setting.
You can specify the print speed for each print 
job via software.
The print speed setting also affects the test 
printouts.

100 mm/s

 for thermal transfer printing: Sensor for 

monitoring the transfer ribbon is activated.
Off

 for thermal direct printing: Sensor for 

monitoring the transfer ribbon is not 
activated.
You can overwrite the setting for each print 
job via software.

On

Warning sent via the Ethernet interface by 
way of an SNMP message or e-mail sent 
when the remaining diameter of the ribbon 
supply roll undershoots the set value 
1.2–3 inches (32–74 mm).

Off