Motorola st7760 Benutzerhandbuch

 

6

 

Your wireless handheld portable telephone is a low power radio 
transmitter and receiver. When it is ON, it receives and also sends out 
radio frequency (RF) signals. 

In August 1996, the Federal Communications Commissions (FCC) 
adopted RF exposure guidelines with safety levels for hand-held 
wireless phones. Those guidelines are consistent with the safety 
standards previously set by both U.S. and international standards 
bodies:

 

•

 

ANSI C95.1 (1992)

 

*

 

•

 

NCRP Report 86 (1986)*

 

•

 

ICNIRP (1996)*

Those standards were based on comprehensive and periodic evalua-
tions of the relevant scientific literature. For example, over 120 sci-
entists, engineers, and physicians from universities, government 
health agencies, and industry reviewed the available body of 
research to develop the ANSI Standard (C95.1).

The design of your phone complies with the FCC guidelines (and 
those standards).

 

*American National Standards Institute; National Council on Radiation Protection and 

Measurements; International Commission on Non-Ionizing Radiation Protection

 

Use only the supplied or an approved replacement antenna. Unau-
thorized antennas, modifications, or attachments could damage the 
phone and may violate FCC regulations.

 

Hold the phone as you would any other telephone, with the antenna 
pointed up and over your shoulder.

 

For your phone to operate most efficiently:

 

•

 

Extend your antenna fully.

 

•

 

Do not touch the antenna unnecessarily when the phone is in use. 
Contact with the antenna affects call quality and may cause the 
phone to operate at a higher power level than otherwise needed.