Enterasys csx400 Benutzerhandbuch
CSX400 and CSX400-DC User’s Guide
55
6
Installation
This chapter outlines the procedure for attaching the CSX400 to the network. Ensure that the
network meets the guidelines and requirements outlined in
network meets the guidelines and requirements outlined in
, before installing the CSX400. To install the HSIM and WPIMs, you need the
following items:
•
Antistatic wrist strap (provided with the CSX400)
•
Phillips screwdriver
Unpacking the CSX400
Unpack the CSX400 as follows:
1.
Remove the shipping material from the box and carefully remove the CSX400.
2.
Visually inspect the CSX400. If there are any signs of damage, contact Cabletron Systems
(refer to the
(refer to the
3.
Read the CSX400 Release Notes included in the shipping box.
Guidelines for Installations
Installation sites must be within reach of the network cabling and meet the requirements listed
below:
below:
•
A properly grounded power receptacle must be within seven feet of the location.
Only qualified personnel should perform installation procedures.
!
CAUTION
Do not connect EPIM ports to the Public Switched Telephone Network (PSTN).
Hazardous voltages exist that may damage the CSX400.
Hazardous voltages exist that may damage the CSX400.