Enterasys csx400 Installationsanweisungen

CyberSWITCH CSX400 and CSX400-DC Installation Guide

2-3

The WPIM-T1/DDS provides both a T1 and DDS interface that allows you to easily switch 
between the two interfaces by changing the physical cabling and reconfiguring QuickSET for 
the desired interface. The WPIM-T1/DDS has the capabilities of both the WPIM-T1 and 
WPIM-DDS.

The CSX400 provides 10 Mbps Ethernet/IEEE 802.3 support through two Cabletron Systems 
Ethernet Port Interface Modules (EPIMs), which are available in a variety of media types. 

, details the available EPIMs that can be used to configure the 

CSX400 for an Ethernet connection.

The CSX400 uses a FLASH Electrically Erasable Programmable 

Read-Only Memory (EEPROM) that allows new and updated firmware to be downloaded in 
conjunction with Cabletron Systems QuickSET or any device using BootP or TFTP protocols.

Cabletron Systems LANVIEW Status Monitoring and Diagnostics System is 

a troubleshooting tool that helps in the diagnosing of power failures, collisions, cable faults, and 
link problems. The LANVIEW LEDs are located on the CSX400 front panel.

The front panel RESET button reboots the CSX400 and initializes the 

processor. The RESET button also is used with the mode switches to clear NVRAM.

The CSX400 can be remotely managed with any SNMP network management system including 
the following:

Cabletron Systems SPECTRUM for Open Systems Suite of Network Management Products

Cabletron Systems QuickSET

Third Party SNMP compliant Network Management Packages