Enterasys csx400 Installationsanweisungen

CyberSWITCH CSX400 and CSX400-DC Installation Guide

C-3

The answer side must be configured for the following:

Ignore DTR state.

Normal DSR operation.

Using the Extended AT(tention) command set listed in the following table to configure the modem:
(Note that each command is preceded by the AT keyword. For example, AT&C1.)

To verify that the settings have been saved, power down the modem, then power it up again and 
enter the AT&$ command.

On the CSX400 select force DTR and RTS on under the corresponding WPIM via the WAN setup 
screen.

&C1

Carrier on after link established (normally the default setting).

&D0

Ignore DTR state (normally the default setting).

&M1

Selects asynchronous command mode/synchronous data mode.

&R1

Selects Real synchronous mode, Real asynchronous mode, and AT command 
mode (normally the default setting).

&S1

DSR normal operation (normally the default setting).

&Y1

Selects user configuration profile #1 to load as the default profile at power-up.

&W1

Save the above settings as user configuration profile number 1.

&$

List the AT& command set settings to verify the configuration.