Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Enterasys
  4. csx200
  5. Benutzerhandbuch

Enterasys csx200 Benutzerhandbuch

Download
Seite von 88
Chapter 5: Troubleshooting
5-6
CSX200 Installation Guide
WPIM-SYNC Installed in CSX200
The port is operating normally. If it is not, and this LED is OFF the port may be disabled or RTS 
may be inactive.
•
Use QuickSET or Local Management to make sure that the WAN interface on the Local device 
is configured correctly.
WPIM-HDSL Installed in CSX200
The port is disabled or has been placed into Loopback Test mode.
•
Use QuickSET or Local Management to make sure that the WAN interface on the Local device 
is configured correctly.
•
Use QuickSET or Local Management to make sure that the WAN interface on the Remote 
device is configured correctly.
Status 1 (STS1) LED is RED
WPIM-T1, WPIM-E1, or WPIM-DI Installed in CSX200 is in RED Alarm Mode
A RED alarm indicates that the WAN connection is not receiving proper framing or has lost 
framing.
•
Verify the use of proper cabling on the WAN connection.
•
Check Frame Type selection on the WAN Physical Configuration and line coding.
•
Possible bad cabling between Telco and CSX200.