Enterasys csx200 Betriebsanweisung
WAN Configuration Using Local Management
CSX200 Family User’s Guide
157
4.
Use the arrow keys to highlight the SAVE command. Then press ENTER. The message “SAVE
DONE!” displays and Local Management saves the changes to memory.
DONE!” displays and Local Management saves the changes to memory.
5.
Access the WAN Interface Configuration screen by using the arrow keys to highlight the WAN
Int Config option, then press ENTER.
Int Config option, then press ENTER.
PPP Interface Configuration
This screen is accessed through the WAN Physical Configuration screen. Refer to
proceed with the following steps to configure the WAN Interface through Local Management.
1.
Use the arrow keys to highlight Interface Number. Set the WAN connection Interface Number
by typing the same number found in the Interfaces field on the WAN Physical Configuration
screen into the Interface Number field, then press ENTER. In this example, the Physical
Configuration screen uses Interface 002 for the WAN connection.
by typing the same number found in the Interfaces field on the WAN Physical Configuration
screen into the Interface Number field, then press ENTER. In this example, the Physical
Configuration screen uses Interface 002 for the WAN connection.
2.
Use the arrow keys to highlight Line Coding. Press the SPACEBAR to select NONE, then
press ENTER.
press ENTER.
3.
Use the arrow keys to highlight Active Protocol. Press the SPACEBAR to select PPP, then
press ENTER.
press ENTER.
4.
Use the arrow keys to highlight PPP Type. Press the SPACEBAR to select BNCP, then press
ENTER.
ENTER.
5.
Use the arrow keys to highlight CCP Enable. Press the SPACEBAR to select ON, if you want
data compression enabled or OFF, if you do not, then press ENTER.
data compression enabled or OFF, if you do not, then press ENTER.
6.
Use the arrow keys to highlight the SAVE command. Press ENTER. The message “SAVE
DONE!” displays and Local Management saves the changes to memory. The interface is
assigned to an application port (PT#) in the table.
DONE!” displays and Local Management saves the changes to memory. The interface is
assigned to an application port (PT#) in the table.
The WAN configuration is complete. It takes up to 60 seconds for the WAN Interface to come out
of standby and for communications to begin.
of standby and for communications to begin.
NOTE
Set Force CTS and Force DSR to YES only if the CSU/DSU does not support these
flow control terms.
flow control terms.