Enterasys csx150 Betriebsanweisung
USER’S GUIDE
282 CyberSWITCH
U
SING
M
ANAGE
M
ODE
C
OMMANDS
Currently you cannot configure SNMP using the Manage Mode, but the following command is
available:
available:
snmp
This Manage Mode command displays the current SNMP configuration data. An example
output screen is shown below:
output screen is shown below:
SNMP C
ONFIGURATION
E
LEMENTS
SNMP S
TATUS
You may enable or disable the SNMP feature.
C
OMMUNITY
N
AME
A 1 to 20 character case-sensitive string that specifies a Community Name that will be accepted by
the SNMP Agent if it is specified in an incoming Request PDU.
the SNMP Agent if it is specified in an incoming Request PDU.
MIB A
CCESS
L
EVEL
The MIB Access Level associated with a Community Name must be selected from the supplied list.
It dictates the level of access available to the associated Community Name. The following is a chart
of the three possible access levels and their access privileges.
It dictates the level of access available to the associated Community Name. The following is a chart
of the three possible access levels and their access privileges.
MANAGE> SNMP
The SNMP feature is enabled.
Current SNMP COMMUNITY NAME Configuration:
id MIB ACCESS LEVEL COMMUNITY NAME
--- -------------------------------------------
1 MIB_ADMIN public
2 MIB_USER user
3 MIB_ADMIN test
--- -------------------------------------------
1 MIB_ADMIN public
2 MIB_USER user
3 MIB_ADMIN test
Current SNMP TRAP RECEIVER List Configuration:
id IP ADDRESS COMMUNITY NAME
----------------------------------------------
1 128.111.001.001 public
2 144.123.111.099 public
3 102.003.003.222 test
----------------------------------------------
1 128.111.001.001 public
2 144.123.111.099 public
3 102.003.003.222 test
The generation of Authentication Failure Traps is disabled.
The generation of ISDN B-Channel Usage Traps is enabled.
The ISDN B-Channel Usage Trap threshold is 5 B-Channels.
The ISDN B-Channel Usage Trap threshold is 5 B-Channels.
Access Level
Access Privileges
MIB GUEST
get (read) MIB-2 system group only
MIB USER
get (read) all MIB-2 and Enterprise MIB objects
MIB ADMIN
get (read) all MIB objects and set (write) all MIB objects
that are writable
that are writable