Enterasys csx150 Betriebsanweisung
Small Office Remote Access Switch 319
C
ONFIGURING
O
THER
A
DVANCED
O
PTIONS
Default Line Protocol
D
EFAULT
L
INE
P
ROTOCOL
The default values for this feature are adequate for most situations. Instructions are included for
the rare instance that you need to alter the configuration.
the rare instance that you need to alter the configuration.
Note:
This feature does not apply to analog connections (including digital modem).
C
ONFIGURING
D
EFAULT
L
INE
P
ROTOCOL
U
SING
CFGEDIT
1.
Select Default Line Protocol from the Options menu.
2.
Change the action on the frame timeout.
3.
Change the frame timeout value.
U
SING
M
ANAGE
M
ODE
lineprot
Displays the current default line protocol configuration.
lineprot change
Allows you to change the default line protocol configuration. For the configuration steps, refer
to the previous CFGEDIT section.
to the previous CFGEDIT section.
D
EFAULT
L
INE
P
ROTOCOL
C
ONFIGURATION
E
LEMENTS
A
CTION
ON
F
RAME
T
IMEOUT
The action to be taken if no frame is received before the configured frame timeout value has
expired. The default value is to disconnect the call. The complete list of choices is as follows:
•
expired. The default value is to disconnect the call. The complete list of choices is as follows:
•
Disconnect
•
Use HDLC Bridge Protocol
•
Use IP Host Protocol (RFC 1294)
•
Use PPP Protocol
F
RAME
T
IMEOUT
V
ALUE
The time limit to wait to receive a packet. The default frame timeout value is 30 seconds. The
possible range is from 5 to 60 seconds.
possible range is from 5 to 60 seconds.
D
EFAULT
L
INE
P
ROTOCOL
B
ACKGROUND
I
NFORMATION
When a connection occurs, the system waits for a packet to arrive, and from that packet, it
determines the protocol type. After a default frame timeout value of 30 seconds, if no packet is
received, the default action on frame timeout is to disconnect the call.
determines the protocol type. After a default frame timeout value of 30 seconds, if no packet is
received, the default action on frame timeout is to disconnect the call.
It is possible to change the timeout value for waiting for responses. You may also change the action
on frame timeout. Instead of disconnecting after the frame timeout value has been reached, you can
select a default protocol for the system to use.
on frame timeout. Instead of disconnecting after the frame timeout value has been reached, you can
select a default protocol for the system to use.