Enterasys csx150 Betriebsanweisung
USER’S GUIDE
350 CyberSWITCH
V
ERIFYING
IP RIP I
NPUT
P
ROCESSING
ON
A
LAN I
NTERFACE
To verify that IP RIP Input Processing (routes learning) is properly operational on a LAN interface,
IP RIP processing must be successfully initialized. Also, a local IP router must be connected to the
local LAN port on the system and capable of propagating routes information via RIP.
IP RIP processing must be successfully initialized. Also, a local IP router must be connected to the
local LAN port on the system and capable of propagating routes information via RIP.
Below is an example of a configuration used to verify IP RIP input processing on a LAN interface.
It uses IP addresses specified to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
It uses IP addresses specified to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
netstat
command. The
netstat
command
displays the IP routing table of the system. Substitute the equivalent command on your IP router.
To verify the operation of IP RIP input processing on a LAN interface:
1.
Determine if the CyberSWITCH has learned the route to 131.1.0.0 from Router 1. On the
administration console type:
administration console type:
ip route
<return>
If the following route entry is displayed among other route entries, the IP RIP input processing
is operational. The ‘P’ (Protocol) field should have ‘R’, which indicates that the entry was
learned via RIP.
is operational. The ‘P’ (Protocol) field should have ‘R’, which indicates that the entry was
learned via RIP.
Destination Subnet-Mask Next Hop Mtr T/P TTL IF AGE
131.1.0.0 255.255.0.0 128.1.1.16 1 R/R 999 n nnn
2.
If the route is NOT displayed, refer to
in the Problem
Diagnosis chapter.
V
ERIFYING
IP RIP O
UTPUT
P
ROCESSING
ON
A
WAN I
NTERFACE
To verify that IP RIP Output Processing (routes advertisement) is properly operational on a WAN
interface, the IP RIP processing must be successfully initialized.
interface, the IP RIP processing must be successfully initialized.
Below is an example of a configuration used to verify IP RIP output processing on a WAN interface.
It uses IP addresses specific to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
It uses IP addresses specific to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
show ip route
command. The
show ip route
LAN 131.1.0.0
Router 1
131.1.1.16
128.1.1.16
128.1.1.1
CSX150