Enterasys csx150 Betriebsanweisung
USER’S GUIDE
508 CyberSWITCH
The TYPE field is Ethernet type field of the LAN frame. This hexadecimal field represents the
protocol identifier for an Ethernet formatted frame. For an 802.3 formatted frame, it is the
length of the data unit.
protocol identifier for an Ethernet formatted frame. For an 802.3 formatted frame, it is the
length of the data unit.
The COUNT field is the number of frames transferred for that destination address, source
address, and Ethernet type combination. The total number of frames is displayed at the bottom
of the screen.
address, and Ethernet type combination. The total number of frames is displayed at the bottom
of the screen.
To exit the MAC Address Monitor screen and disable the feature, press
<Esc>
on the
Administration console keyboard.
br stats
Displays the current system packet statistics. Refer to
, for a list of available
bridge statistics and their definitions.
br stats clear
Clears the current system packet statistics.
C
ALL
C
ONTROL
C
OMMANDS
The following commands are used to initiate and disconnect calls to devices.
call device <device name>
Initiates a call to the specified device. The entire device name does not need to be entered; only
enough letters of the name to distinguish it from any other configured device name. For
example, you could enter
enough letters of the name to distinguish it from any other configured device name. For
example, you could enter
call device sm
if there are no other devices whose names begin
with
sm
. The call device command can be used to test the Dial Out capability to a specific
device. This command is available only when the Authentication mode is “On-node Device
Table.” To obtain the device name, enter the Manage Mode and issue the
Table.” To obtain the device name, enter the Manage Mode and issue the
device
command.
Note that the device name is case sensitive.
To use this command for troubleshooting, you must use the System Call Trace feature to
capture any connect and disconnect messages that are generated by issuing the
capture any connect and disconnect messages that are generated by issuing the
call device
command. To do this:
1.
Erase the current report log by entering
er
at the system prompt.
2.
Enable the Call Trace feature by entering
trace on
at the system prompt.
3.
Issue the
call device <device name>
command.
4.
Display the system log messages by entering the
dr
command at the system prompt.
5.
Check the log report for connect messages relating to the remote device you are testing.
In response to the
call device <device name>
command, one of the following responses
will be displayed:
Calling device <device name>
Indicates that a call request process has been initiated.