Enterasys atx Verweisanleitung
Chapter 11: Traps
11-8
ATX MIB Reference Guide
•
IpbkOperation – Sent whenever the unit has finished a loop back test, or a
loop back error has been detected. The following parameters are also
included:
loop back error has been detected. The following parameters are also
included:
-
lpbkErrorNoReceives – Sent in conjunction with lpbkOperation; This
variable does not need to be acknowledged.
variable does not need to be acknowledged.
-
lpbkErrorBadReceives – Sent in conjunction with lpbkOperation; This
variable does not need to be acknowledged.
variable does not need to be acknowledged.
•
swanLinkCost – Obsolete.
•
swanMeshState – Obsolete.
•
swanLinkSubnet – Obsolete.
•
swanLinkBridge – Obsolete.
•
swanLinkPort – Obsolete.
•
srptrLinkStatusMask – Sent whenever the status of any of a repeaters’s port
has changed. This variable is obsolete.
has changed. This variable is obsolete.
11.4
PRIORITY 2 TRAPS
Priority 2 Traps are the lowest priority enterpriseSpecific Traps, and are only sent
if both configAlarmAddresses and configAlarmDynamic are True. Each trap
contains just the addrAlarmMAC parameter, and is sent if the learned
information concerning that address table entry has changed. The trap is
acknowledged by using the Addresses Configuration Group parameters to obtain
the address table entry specified by addrAlarmMAC, and receiving a
GetResponse with the addrMAC parameter.
if both configAlarmAddresses and configAlarmDynamic are True. Each trap
contains just the addrAlarmMAC parameter, and is sent if the learned
information concerning that address table entry has changed. The trap is
acknowledged by using the Addresses Configuration Group parameters to obtain
the address table entry specified by addrAlarmMAC, and receiving a
GetResponse with the addrMAC parameter.