Enterasys D2G124-12P Installationsanweisungen
Mounting the Switch
Enterasys D-Series Hardware Installation Guide 2-15
8.
Plug the DC power cord from the power supply into the switch DC power receptacle that is
appropriate for your type of power supply.
appropriate for your type of power supply.
•
For the D2‐PWR supply, plug into the PWR1‐A or PWR2‐A receptacle.
•
For the D2‐PWR‐POE supply, plug into the PWR1‐B or PWR2‐B receptacle.
•
For the D2‐HIPWR‐POE power combiner, see “
9.
Plug the AC cord into the power supply’s AC receptacle.
10. (Optional) Use the wire ties provided to secure the power cords inside the wall mounting tray.
11. Using appropriate screws and the screw holes in each corner edge of the wall mounting tray,
attach the assembled kit to your desired wall location. Secure the assembled unit in place by
positioning the screw holes over the installed wall screws and pulling slightly downward on
the unit.
positioning the screw holes over the installed wall screws and pulling slightly downward on
the unit.
12. Attach network cables. Refer to “
” on page 2‐28 for more
information.
13. Plug each AC power cord into a dedicated, grounded AC outlet. See “
” on page 2‐26 for information on redundancy and the initialization process.
14. (Optional) If you have purchased an optional plastic cover, attach it to the mounted D2 switch
as described in “
Installing the Switch in the Lockbox and Mounting on a Wall
To assemble the switch and other components in the D2 lockbox, proceed as described in the
following sections:
following sections:
•
•
Install your power supplies, following the steps in either “
(page 2‐16) or “
•
•
•
•
Installing the Switch in the Lockbox
To install the switch in the lockbox tray, proceed as follows:
1.
Detach the lockbox key and place it in a secure location for later use.
Note: Once assembled, the serial number on the bottom of your D2 switch will be accessible
through the window on the bottom of the wall mounting tray. In the event you need to view it, you will
need to detach the wall mounting tray from the wall and (if installed) remove the power supply from
underneath the serial number window.
through the window on the bottom of the wall mounting tray. In the event you need to view it, you will
need to detach the wall mounting tray from the wall and (if installed) remove the power supply from
underneath the serial number window.