Enterasys fn100 Betriebsanweisung
Installing the FN100
Fast Network 100 User Guide
Page 2-3
2.3.2 Rack-Mounting the FN100
The table below describes some general considerations you should be
aware of before mounting the FN100 in a rack assembly.
aware of before mounting the FN100 in a rack assembly.
The FN100 can be rack-mounted in a standard 19-inch equipment cabinet
(EIA RS310C). To mount the FN100 in a rack assembly, apply the
following steps:
(EIA RS310C). To mount the FN100 in a rack assembly, apply the
following steps:
1. Attach the rack-mount brackets to either side of the FN100
chassis.
2. Place the FN100 chassis in the cabinet.
Table 2-1
General Considerations for Mounting the FN100
Consideration
Discussion
Temperature
Since the temperature within a rack assembly may
be higher than the ambient room temperature,
make sure the rack-environment temperature is
within the Operating Temperature range specified in
Appendix A.
be higher than the ambient room temperature,
make sure the rack-environment temperature is
within the Operating Temperature range specified in
Appendix A.
Air Flow
Make sure there is at least 2 inches (or more) on
both sides of the FN100 to allow for adequate air
flow.
both sides of the FN100 to allow for adequate air
flow.
Mechanical Loading
Do not place equipment on top of a rack-mounted
FN100.
FN100.
Circuit Overloading
Make sure the power supply circuit to the rack
assembly is not overloaded.
assembly is not overloaded.
Grounding (Earthing)
Rack-mounted equipment should be grounded. In
addition to the direct connections to the main power
supplies, make sure all the other supply
connections are also grounded.
addition to the direct connections to the main power
supplies, make sure all the other supply
connections are also grounded.
NOTE
The FN100 may have been shipped with the rack-mount
brackets already installed.
brackets already installed.