Enterasys fn100 Verweisanleitung

Chapter 6: Cabletron MIB

sfadmin

{es-1fe 3}

This group contains the attributes for configuring the system level control of the 
entire FN100 and the overall FN100 status. 

sfadminFatalErr

{sfadmin 1}

Octet String Read-Only 

This is a 32 byte array which contains information about the cause of the 
previous system reset. This will describe the circumstances which forced the 
system software to perform a reboot. The values in the first byte have the 
following meanings:

(0)

Power failure

(1)

Watchdog Timeout

(2)

NMS Requested Shutdown; next three bytes are not applicable; 
next four bytes contain the NMS’s IP address; remaining 24 bytes 
are not applicable) 

(3-255)

Fatal Error

sfadminAnyPass

{sfadmin 2}

Octet String Read-Write 

The authentication password (0-24 bytes) which must match the community 
name in an SNMP Get, Getnext, or Set PDU, in order for the operation to be 
performed. A zero length password indicates that any community name is 
acceptable. 

sfadminGetPass

{sfadmin 3}

Octet String Read-Write 

The authentication password (0-24 bytes) which must match the community 
name in an SNMP Get or Getnext PDU (except for debug or password 
parameters). A zero length password indicates that any community name is 
acceptable. Alternatively, it is acceptable if the community name matches 
sfsdminAnyPass, defined above.

2

2. 

Certain SetRequest PDUs are used for read operations and using 

sfadminGetPass for the community name is sufficient. Those special conditions 
consist of SetRequest PDUs for sfaddrOperation (for read-random, read-next, 
and read-block only), and for all MIB variables in the sfaddr group described as 
Write-Ignore.