Enterasys 6h302-48 Benutzerhandbuch

Unpacking the Module

3-2

Installation

3.1

UNPACKING THE MODULE

Unpack the module as follows:

1. Open the box and remove the packing material protecting the module.

2. Verify the contents of the carton as listed in

Table 3-1

3. Remove the tape seal on the non-conductive bag to remove the module.

4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys

Networks if there are any signs of damage. Refer to “

Getting Help

” for details.

3.2

INSTALLING OPTIONAL FLASH UPGRADE

If the module is to be installed with an optional FLASH upgrade, refer to

Appendix B

for complete

installation instructions.

3.3

INSTALLING THE MODULE INTO THE MATRIX E7 CHASSIS

The module can be installed in any of the slots that are available.

Table 3-1

Contents of Module Carton

Item

Quantity

One module, either the 6H302-48 or the 6H303-48

Antistatic Wrist Strap

Manual Accessory Kit

NOTE: Install any optional equipment before proceeding to

Section 3.3

CAUTION: Failure to observe static safety precautions could cause damage to the
module. Follow static safety handling rules and wear the antistatic wrist strap provided
with the Matrix E7 chassis.

Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.