Enterasys 7h4284-49 Installationsanweisungen

To connect a VT Series terminal to an Enterasys Networks DFE module COM port (

use a UTP straight-through cable with RJ45 connectors and an optional RJ45-to-DB25 female 
adapter, and proceed as follows:

1. Connect the RJ45 connector at one end of the cable to the COM port on the Enterasys Networks 

module.

2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 female adapter.

3. Connect the RJ45-to-DB25 adapter to the port labeled COMM on the VT terminal.

4. Turn on the terminal and access the Setup Directory. Set the following parameters on your 

terminal:

When these parameters are set, the Local Management password screen will display. Refer to the 
Enterasys Matrix DFE-Platinum Series Configuration Guide for further information.

Mode

7 Bit Control

Transmit

Transmit=9600

Bits Parity

8 Bits, No Parity

Stop Bit

1 Stop Bit