Enterasys 7h4284-49 Installationsanweisungen
Memory Locations and Replacement Procedures
B-8
Mode Switch Bank Settings and Optional Installations
Figure B-5
Installing the DRAM SIMM
B.3.3
DIMM Replacement Procedure
In the event that the DIMM needs to be replaced, the following sections explain how to remove
and install the DIMM. If you have questions concerning the replacement of the DIMM, refer to
and install the DIMM. If you have questions concerning the replacement of the DIMM, refer to
on page xviii for details on how to contact Enterasys Networks.
Removing the DIMM
To remove the existing DIMM, proceed as follows:
for the DIMM
location on the 7H4284-49.
1 Connector arms
3 Connector fingers
2 DRAM SIMM memory module
4 Alignment notches (2)
Note: To access and remove a DIMM, you may need to remove the optional network
expansion module (NEM), if one is installed in your DFE module. To remove the NEM,
refer back to the instructions in the section, “
expansion module (NEM), if one is installed in your DFE module. To remove the NEM,
refer back to the instructions in the section, “
Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
precauciones de seguridad para evitar descargas de electricidad estática.
Â
À
À
Á
Ã
Ã