Enterasys c1g124-24 Benutzerhandbuch

This guide provides information necessary to install and set up the Matrix C1 Series C1H124-48 
and C1G124-24 devices and available options.

For information about the Command Line Interface (CLI) set of commands used to configure and 
and manage the C1H124-48 and C1G124-24, refer to the Enterasys Networks™ Matrix C Series 
Configuration Guide.

For information about connecting optional redundant power source, refer to the Enterasys 
Networks™ Matrix C Series Redundant Power System Installation Guide.

This guide is intended for a network administrator responsible for installing and setting up the 
device.

NOTE: In this guide, the following terms are used:

Device, unless noted differently, refers to both the C1H124-48 and C1G124-24.

Mini-GBIC (Mini-Gigabit Interface Card) refers to an optional small form interface 
module that plugs into the fixed front panel Mini-GBIC slots.

Depending on the firmware version used in the C1H124-48 

and 

C1G124-24, some features 

described in this document may not be supported. Refer to the Release Notes shipped with the 
device to determine which features are supported.

ELECTRICAL HAZARD: Only qualified personnel should perform the installation 
procedures in this guide.