Enterasys c1g124-24 Benutzerhandbuch

3. Observe that the power (RPS) LED (not shown), located on the front panel, turns ON (green) 

and the CPU turns red until the device completes its initialization. It takes under 30 seconds for 
the device to boot up.

4. If you are installing an optional redundant power system (RPS), refer to the Matrix C Series 

Redundant Power System Installation Guide supplied with the RPS. The RPS chassis is 
connected to the 15-pin D-type connector

 

 

 using a DC Power/Monitor cable. 

The following procedures cover the cable connections from the network or other devices to either 
the C1H124-48 or C1G124-24 any installed optional Mini-GBIC. 

Connecting UTP Cables (

Connecting Fiber-Optic Cables to Mini-GBICs (

 

AC power cord

 

AC power outlet

 

AC power receptacle 

 

D-type connector for external redundant power supply

NOTE: If the power-up sequence is interrupted on this device, or if optional hardware 
has been installed or removed, this device may run an extended diagnostics sequence 
that may take up to two minutes to complete.

3831_01_06

Â

Á

À

Ã