Enterasys 5g102-06-g Installationsanweisungen
Connecting the 5G106-06 to the Network
3-16
Installation
To connect the GPIM-09 to the network using multimode fiber, perform the following steps:
1. Connect Launch Mode Conditioning cable to the multimode fiber on both ends of the multimode
cable, before connecting the SmartSwitch with a GPIM-09 to the multimode fiber cabling. See
.
Figure 3-13
GPIM-09 Launch Mode Conditioning Cable Connection
2. Once the Launch Mode Conditioning cable is connected to the ends of the multimode fiber optic
to complete the installation to the GPIM-09 device.
3.6.3
5G106-06 Network Connection
To connect the module using fiber optic cable to the network, perform the following steps:
1. Remove any protective covers from the fiber optic ports and from the ends of the connectors.
NOTE: If connecting the module with a GPIM-09 to the network using multimode fiber
optic cable, refer to
optic cable, refer to
before following this procedure.
WARNING: The GPIM-08 and GPIM-09 use Class 1 lasers. Do not use optical
instruments to view the laser output. The use of optical instruments to view laser output
increases eye hazard. When viewing the output optical port, power must be removed
from the network adapter.
instruments to view the laser output. The use of optical instruments to view laser output
increases eye hazard. When viewing the output optical port, power must be removed
from the network adapter.
Installed multimode
fiber cable
Long Wavelength
Gigabit Fiber Device
Launch Mode
Conditioning
Cable
Launch Mode
Conditioning
Cable
Long Wavelength
Gigabit Fiber Device
3587_04
Connect the ends of the
multimode cable to the
Launch Mode Conditioning
Cable