Enterasys 6000 Betriebsanweisung
Configuring Frame Relay
6-29
Configuring Subscriber Addresses
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
[A]
at the Connections and
Routing Paths Menu (or
[A], [D], [A]
from the Main Menu).
To add or change a Subscriber ID, press
[B]
at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described in Appendix A).
described in Appendix A).
Figure 6-9 SVC Subscriber Display
[A],[D],[B]
from Main Menu
Pressing
[G]
will display configured routing paths, which link the subscriber device
with one or more ports. Pressing
[H]
will display a list of addresses used for call redi-
rection. (These addresses are valid only if
Y
is specified for one or more of items C,
D, and E on the first screen.) Parameters for all three screens are described following
Table 6-6 (on page 6-30).
Table 6-6 (on page 6-30).
Node Name=nod e_xyz
SV C Sub scriber Main ten ance
*
S ubs criber ID
0100012345
A S ubs criber Name
sub 1
B R outing Algorithm
0, Roun d Robin
C S ystematic Redirection
N
D R ed irect on Busy
N
E R ed irect on Ou t of Order
N
F C onnection Priority
0
G R outing Path s
H R ed irection Ad dres ses
H R ed irection Ad dres ses
Option: