Enterasys 6000 Betriebsanweisung
12-10
FRX/FRM 3. 3 User G uide, Rev 04
Configuring IPX Interfaces
An IPX interface allows an FRX/FRM to connect to a Novell IPX network. Press
[E]
at the
LAN Interfaces Configuration Menu
(or
[A], [C], [F], [E]
from the Main Menu) to
display configured IPX interfaces.
To configure an interface, press
[F]
at the LAN Interfaces Configuration Menu. When
prompted, enter an
Interface Number
:
0–63
. (This is merely a sequential number to
identify the interface.)
Do not specify an interface number that has already been used
for an IP interface, LLC2 interface, or Bridge port on this node.
for an IP interface, LLC2 interface, or Bridge port on this node.
The display depends on the interface; the following figure shows an example, and
Table 12-7 through Table 12-10 list the parameters for all interface types.
Table 12-7 through Table 12-10 list the parameters for all interface types.
Figure 12-4 IPX Interface Record Example
[A],[C], [F],[F]
from Main Menu
IPX Interface C onfiguration
*
In terface Nu mber
2
A Block ed Port Flag
N
B In terface Type
Ethern et
C Frame Type
TYPE_II
D Maximu m Trans mis sion U nit
4096
E IPX Network Add ress
00000001
F Priority
0
G Band width Allocation Group
1
H Port Diagnos tics Enabled
Y
I
NetBIOS Enab led
N
J
NetBIOS Hops
8
K Periodic RI P Enabled
Y
L Periodic RI P Timer (s ec)
60
M Periodic SA P Enabled
Y
N Periodic SA P Timer (s ec)
60
O Ad dition al IPX Parameters
Op tion :