Enterasys 6a000 Verweisanleitung

2-176 SmartCell 6A000/ZX-250 Reference Manual

Console Commands

Descriptions

Examples

switch_prompt # add route

DestNetIP() : 204.95.77.187

GatewayIP() : 204.95.77.186

switch_prompt #

switch_prompt # show route

ROUTE NET TABLE

destination gateway flags Refcnt Use Interface

------------------------------------------------------------------------

90.1.1.0 90.1.1.186 1 0 6508 zn1

204.95.77.0 204.95.77.186 1 3 6312 ei0

------------------------------------------------------------------------

ROUTE HOST TABLE

destination gateway flags Refcnt Use Interface

------------------------------------------------------------------------

127.0.0.1 127.0.0.1 5 0 0 lo0

204.95.77.187 204.95.77.186 5 0 0 ei0

------------------------------------------------------------------------

switch_prompt #

switch_prompt # delete route

DestNetIP() : 204.95.77.187

GatewayIP() : 204.95.77.186

switch_prompt #

Operator

Parameters/Permissions

Description

add route

[DestNetIP] <destnetip>

[GatewayIP] <gatewayip>

Administrator

Creates an IP route to an ATM client when it is not directly
connected to the NMS (network management system). You
must assign both the destination IP address and the gateway IP
address to reach the ATM client, and these addresses must
already exist.

delete

route

[DestNetIP] <destnetip>

[GatewayIP] <gatewayip>

Administrator

Removes an IP route from the switch configuration when it is
not directly connected to the NMS.

show route

All

Displays IP routes used by the switch. The flag numbers shown
in the flags column relate to the hexadecimal figures listed in the
Output Parameter table above. Whatever number is shown
defines what flags are active. For example, 1 equals flag 0x1; 5
equals flag 0x1 + flag 0x4; 7 equals flag 0x1 + flag 0x2 + flag
0x4 and so on.