Enterasys zx-250 Installationsanweisungen
SmartCell ZX Administrator Installation Guide 2-1
2
INSTALLATION
You can install SmartCell ZX Administrator on a PC running Windows NT 4.0, Windows NT 3.51, or Windows 95.
You can install the software from the diskette drive (drive a:) on your PC or from a server on your network.
You can install the software from the diskette drive (drive a:) on your PC or from a server on your network.
After you read this chapter, you will be able to install the application on the following platforms:
•
Windows NT 4.0
•
Windows NT 3.51
•
Windows 95
2.1
HARDWARE REQUIREMENTS
Before you install SmartCell ZX Administrator, verify that your PC has the following hardware:
•
Pentium 133 or faster processor
•
20 MB disk space
•
32 MB RAM
•
Monitor with resolution of at least 800 x 600 resolution
•
IP network connection to the switch you manage
2.2
INSTALLING SMARTCELL ZX ADMINISTRATOR
ON WINDOWS NT 4.0
ON WINDOWS NT 4.0
2.2.1
Software Requirements
Before you install SmartCell ZX Administrator, verify that the Windows NT 4.0 operating system is installed on your
PC.
PC.
2.2.2
Installation Steps
Follow these steps to install SmartCell ZX Administrator.
1.
If you are using diskettes, make backup copies of the SmartCell ZX Administrator diskettes. Put the
original diskettes in a safe place; use them if your backup copies become unusable. Use your backup
copies to complete the installation procedure.
original diskettes in a safe place; use them if your backup copies become unusable. Use your backup
copies to complete the installation procedure.
2.
Load Disk1 into drive a or note the network <path> to the directory that contains the SmartCell ZX
Administrator files. The term <path> is the location of the files on your server.
Administrator files. The term <path> is the location of the files on your server.
3.
Click Start then click Run.