Enterasys 1805 Betriebsanweisung
9033259
ELS100-S24TX2M User Interface 25
IP Connectivity Test (Ping)
Use the IP Connectivity Test to see if another site on the Internet can be
reached. The screen shown below is described in the following table.
Figure 2-9. IP Connectivity Test
Parameter
Default Description
BOOTP Get IP - IP is enabled but will not function
until a BOOTP reply has been
received. BOOTP requests will
be periodically broadcast by the
switch in an effort to learn its IP
address. (BOOTP values can
include the IP address, default
gateway, subnet mask, TFTP
boot file name, and TFTP server
IP.)
received. BOOTP requests will
be periodically broadcast by the
switch in an effort to learn its IP
address. (BOOTP values can
include the IP address, default
gateway, subnet mask, TFTP
boot file name, and TFTP server
IP.)
SmartSTACK Local Management -- ELS100-S24TX2M
Network Configuration: IP Connectivity Test (Ping)
IP Address : 200.123.211.109
Test Times : 1 Interval : 3
Success : 0 Failure : 0
[Start]
<OK>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Description
IP Address
IP address of the site you want to ping.
Test Times
The number of ICMP echo requests to send to the specified site.
Range: 1~1000
Range: 1~1000
Interval
The interval (in seconds) between pinging the specified site.
Range: 1~10 seconds
Range: 1~10 seconds
Success/Failure
The number of times the specified site has responded or not to
pinging.
pinging.