Enterasys 1805 Betriebsanweisung
![Enterasys](https://files.manualsbrain.com/attachments/0d61cd0d9a60e36f1a6c1364af6a0a9788bcf75b/common/fit/150/50/0c43aa9c6913c8f0c68912f62e6506afc95280a8d9a1fc71e52e7f54646e/brand_logo.jpeg)
42 ELS100-S24TX2M User Interface
ELS100-S24TX2M
Parameter
Description
Type
Shows port type as:
10/100TX : 10Base-T / 100Base-TX
100FX :
10/100TX : 10Base-T / 100Base-TX
100FX :
100Base-FX
1000SX :
1000Base-SX
1000LX
: 100Base-LX
Status
Displays the current state of this port within the spanning tree:
Disabled
Disabled
Port has been disabled by the user or has failed
diagnostics.
diagnostics.
Blocking
Port receives STA configuration messages, but does
not forward packets.
not forward packets.
Listening
Port will leave blocking state due to topology change,
starts transmitting configuration messages, but does
not yet forward packets.
starts transmitting configuration messages, but does
not yet forward packets.
Learning
Has transmitted configuration messages for an
interval set by the Forward Delay parameter without
receiving contradictory information. Port address
table is cleared, and the port begins learning
addresses.
interval set by the Forward Delay parameter without
receiving contradictory information. Port address
table is cleared, and the port begins learning
addresses.
Forwarding The port forwards packets, and continues learning
addresses.
The rules defining port status are:
•
A port on a network segment with no other STA compliant
bridging device is always forwarding.
bridging device is always forwarding.
•
If two ports of a switch are connected to the same segment
and there is no other STA device attached to this segment,
the port with the smaller ID forwards packets and the other is
blocked.
and there is no other STA device attached to this segment,
the port with the smaller ID forwards packets and the other is
blocked.
•
All ports are blocked when the switch is booted, then some
of them change state to listening, to learning, and then to
forwarding.
of them change state to listening, to learning, and then to
forwarding.
Designated Cost
The cost for a packet to travel from this port to the root in the
current spanning tree configuration. The slower the media, the
higher the cost.
current spanning tree configuration. The slower the media, the
higher the cost.
Designated Bridge
(ID)
(ID)
The priority and MAC address of the device through which this
port must communicate to reach the root of the spanning tree.
port must communicate to reach the root of the spanning tree.
Designated Port (ID)
The priority and number of the port on the designated bridging
device through which this switch must communicate with the root
of the spanning tree.
device through which this switch must communicate with the root
of the spanning tree.