Enterasys 1805 Betriebsanweisung
9033259
Configuring & Monitoring the Switch 71
Configuring Port Mirroring
You can mirror the traffic being switched on any port for the purposes of
network traffic analysis and connection assurance. When Port Mirroring
is enabled, one port becomes a monitor port for any other port within the
stack. Note that the source and target ports must be configured within the
same VLAN and be operating at the same speed. If the target port is
operating at a lower speed, the source port will be forced to drop its
operating speed to match that of the target port.
To configure port mirroring, do the following:
1. Select Device Control Menu from the Main Menu.
2. Select Mirror Port Configuration.
3. For the Mirror Source Port, select the stack unit and port number.
4. For the Mirror Target Port, select the stack unit and port number.
5. Set the Status field to ENABLED.
6. Connect a traffic analyzer or RMON probe to the mirroring port.
Downloading a Software Upgrade
You can upgrade the operational software in the ELS100-S24TX2M
switch without physically opening the switch or being in the same location.
The software storage sector in the flash memory of the switch is
reprogrammable, allowing you to easily download software feature
enhancements and problem fixes to the switch from a local or remote
location.
Software can be downloaded to the switch in two ways:
•
Via the serial port. This procedure is an out-of-band operation that
copies the software through the serial port to the switch. This
operation takes approximately 10 minutes and requires minimal
configuration.
•
Via TFTP download. This procedure uses a TFTP server connected
to the network and downloads the software using the TFTP protocol.
A TFTP download is much faster than a serial download, requiring
only a few seconds, and can be used to upgrade an
ELS100-S24TX2M switch that is not physically proximate. The
disadvantage is that this method requires a TFTP server and
additional setup.