Enterasys els10-27tx Benutzerhandbuch

Introduction

1-7

This command will allow you to specify a list of VLAN IDs that should not be 
dynamically learned by GVRP. When the management processor receives a 
GVRP packet, it checks this database to determine if the learning of this ID 
should be restricted.

For usage, refer to the VLAN Command in Chapter 2, Enhancements to LCM 
Commands.

GVRP can be enabled on a per port basis using the Port command.

For further information, refer to the Port Command in Chapter 2, Enhancements 
to LCM Commands.

 

There is no support for GVRP with ELS10-27TX Version 1.01.00. 
  

 

There is no support for GVRP with ELS10-27TX Version 1.01.00.