Danby dpac13009 Benutzerhandbuch

The power cord supplied with this air conditioner contains a device

that senses damage to the power cord. To test if your power cord is

working properly, you must do the following:

savings. Follow these recommendations for greater efficiency. 

1) Select a thermostat setting that suits your

comfort needs and leave at that chosen 

setting. 

2) The air filter is very efficient in removing 

airborne particles. Keep the air filter clean at all

times.

3) Use drapes, curtains or shades to keep

direct sunlight from penetrating and heating

room, but do not allow drapes or curtains to

obstruct the air flow around the unit.

4) Start your air conditioner before the 

outdoor air becomes hot and uncomfortable, to

avoid an initial period of discomfort while the

unit is cooling off the room. Use of the 

automatic start/stop programmable TIMER

feature can be a major asset in this regard if

utilized to the fullest extent. 

5) When outdoor temperatures are cool

enough, turn the air conditioner off and use the

FAN MODE on HIGH, MED, or LOW. This 

circulates indoor air, providing some cooling

comfort while utilizing less electricity. 

NOTE: The power cord supplied with this air 

conditioner contains a current leakage detection

device designed to reduce the risk of fire. In the

event the power supply cord is damaged, it cannot

be repaired and must be replaced with a new cord

from the product manufacturer. 

• Under no circumstances should this device be

used to turn the unit on or off. 

• The “RESET” button must always be pushed in

(engaged) for correct operation.

• The power supply cord must be replaced if it fails

to reset when the “TEST” button is pushed in.

1) Connect the power supply cord to an 

electrical outlet.

2) The power supply cord has two buttons

located on the head of the plug. One button is

marked “TEST”, and the other is marked

“RESET”. Press the “TEST” button; you will

hear a click as the “RESET” button pops out.

3) Press the “RESET” button; you will hear a

click as the button engages.

4) The power supply cord is now energized

and supplying electricity to the air conditioner

(on some products this is also indicated by a

light on the plug head). 

CAUTION: During air conditioning and 

dehumidifier mode, if the compressor cycle is

interrupted (water full condition, unplugged,

power failure, etc.) and reinstated immediately

thereafter (within 3-5 minutes), a compressor 

protection circuit is automatically activated. The

compressor cannot operate during compressor 

protection mode (this is normal). It may take 3-5

minutes before the protection circuit 

self-deactivates.

This unit is equipped with a fail-safe switch

mechanism that prevents the unit from 

condensing water in the event the internal

reservoir becomes full or is accidentally 

displaced. If this situation occurs, the (RED)

WATER FULL indicator light will illuminate.

This condition will remain steady until the

external water tank is emptied. 

NOTE: No cooling will occur until the internal

tank is emptied and/or re-positioned. It may

take several minutes before the compressor

resumes normal operation. 

4