Sony ht-ddw795 Handbuch

The measurement process will take a few 
minutes to complete.
The table below shows the display when 
measurement starts.

* The corresponding speaker indicator lights 

up in the display during measurement.

“COMPLETE” appears on the display 
and the settings are registered.

Auto Calibration cannot detect the sub woofer. 
Therefore, all sub woofer settings will be 
maintained.

During the measurement process, Auto Calibration 
is canceled when you do the following.
– Press ?/1, input buttons or MUTING.
– Change the volume level.
– Press AUTO CAL again.

When an error is detected during Auto 
Calibration, an error code will appear on the 
display cyclically after each measurement 
process as follows:
Error code 

t blank display t (error code t 

blank display)

a)

 

t PUSH t blank display 

t ENTER

a)

Appears when there are more than one error code.

Record down the error code.

Press .

Press ?/1 to turn off the receiver.

Rectify the error.
For details, see “Error codes and remedies” 
below.

Turn on the receiver and perform Auto 
Calibration again (page 22).

Environment noise 
level

NOISE.CHK

Speaker connection MEASURE and SP 

DET. appears 
alternately*

Speaker level

MEASURE and GAIN 
appears alternately*

Speaker distance

MEASURE and 
DISTANCE appears 
alternately*

ERROR 10

The environment is too noisy. 
Make sure the environment is quiet 
during Auto Calibration.

ERROR 11

The speakers are placed too near 
the optimizer microphone. Place 
your speakers further away from 
the optimizer microphone.

ERROR 12

None of the speakers are detected. 
Make sure that the optimizer 
microphone is connected properly 
and perform Auto Calibration 
again.

ERROR 20

Front speakers are not detected or 
only one front speaker is detected. 
Check the front speaker 
connection.

ERROR 21

Only one surround speaker is 
detected. Check the surround 
speaker connection.