EchoStar dvr-5000 hdd Zusätzliches Handbuch
Section 4
EchoStar International Corporation
Page 4 - 5
© 2
002 E
choS
tar
Inte
rnati
onal
C
o
rp
orat
io
n
A
ll ri
gh
ts
re
se
rv
ed
4
2.2.1. SYSTEM SETUP SUB-MENU - EASY
DVR-7000 HDD
ONLY
This sub-menu allows you to customize the system setup to match your installation. Note that
the menu page is dynamic which means that it changes with the selections you make. You
can customize:
the menu page is dynamic which means that it changes with the selections you make. You
can customize:
■
System
To select the dish type you use.
To select the dish type you use.
■
Installation (fixed, motorized only)
To select the guided setup procedure for Easy
installations or Advanced installations with multiple
user defined LNBs.
To select the guided setup procedure for Easy
installations or Advanced installations with multiple
user defined LNBs.
■
LNBs
To set the amount of LNBs you have installed.
To set the amount of LNBs you have installed.
■
Polarity
To set the device that controls the signal polarity.
To set the device that controls the signal polarity.
■
Switch
To set the switch type which you use to control the
dish installation (if used).
To set the switch type which you use to control the
dish installation (if used).
■
LNB1
To set the LNB type(s) you use.
To set the LNB type(s) you use.
■
SAT (for fixed only)
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
■
Method (for motorized only)
To set the channel search method;
AutoSat (automatically calculate the satellite
positions from reference positions)
Manual (enter the satellites by manual search).
To set the channel search method;
AutoSat (automatically calculate the satellite
positions from reference positions)
Manual (enter the satellites by manual search).
■
AutoSat (for motorized, AutoSat only)
To confirm the selections you made and advance to
the AutoSat setup page (AutoSat only)
To confirm the selections you made and advance to
the AutoSat setup page (AutoSat only)
■
Set limits (for motorized, manual only)
To confirm the selections you made and advance to
the Set limits page.
To confirm the selections you made and advance to
the Set limits page.
■
Check signal (for fixed only)
To confirm the selections you made and advance to
the Check signal page.
To confirm the selections you made and advance to
the Check signal page.
■
Symbol rate1-4 (for SMATV only)
To set the symbol rate you want to scan.
To set the symbol rate you want to scan.
■
Search channels (for SMATV only)
To confirm the selections you made and advance to
the Search channels page.
To confirm the selections you made and advance to
the Search channels page.