Yamaha RX-Z11 Betriebsanweisung

In this menu, you can perform the following operations:
• Press 9n and select “Setup” to set the measured values.
• Press 9k and select “Retry” to retry the automatic setup 

procedure. This unit starts the automatic setup procedure 
immediately again.

• Press 9h and select “Detail” to view information about 

measurement results and warning messages. In the 
information display, press 9k / n repeatedly to toggle 
between the parameters. See page 50 for details.

• Press 9l to cancel the measurement results and exit from 

the automatic setup menu.

Press I

MENU to turn off the GUI menu.

• After you have completed the automatic setup procedure, be sure to 

disconnect the optimizer microphone.

• The optimizer microphone is sensitive to heat. Keep it away from direct 

sunlight and do not place it on top of this unit.

■ Reviewing the result of the automatic setup

Use this feature to review the result of the automatic setup.

Set the operation mode selector to F

AMP and then 

press I

MENU to turn on the GUI screen.

Press 9k / n repeatedly and then 9h to select 
“Auto Setup”.

Press 9k to select “Information”.

Press 9h and then 9k / n repeatedly to select the 
desired check items.

When this unit detects potential problems during the 
automatic setup procedure, error or warning messages 
appears in the result display. See the “Auto Setup” section 
in “Troubleshooting” on page 152 for a complete list of 
error or warning messages and proper remedies.
Press 9l to view the detailed information of the error or 
warning messages.