Zhone 2004 Betriebsanweisung

Seite von 216
C o n f i g u r a t i o n
4-19
6
Type “Y” to add more routes, or Escape to cancel. Repeat these steps for 
each route that you want to add.
7
Continue with other configuration tasks, or press Escape to return to the 
Router Modification menu.
Remove a Route
To delete a static route from the Route Table, follow the steps below:
1
On the Router Modification menu, type “R” to select Remove a Route. The 
IAD prompts you to enter the address of the route to remove:
2
Type the IP address of the route to remove and press Enter. The IAD 
removes the route from the table and the IAD displays the Router 
Modification menu. Repeat these steps for each route that you want to 
remove.
3
Continue with other configuration tasks, or press Escape to return to the 
Main menu.
Add or Change Default
Route
To add or change a default route, follow the steps below.
1
On the Router Modification menu, type “F” to select Add/Change the 
Default Route. The IAD prompts you to enter the default gateway address. 
(You may type “0” for a list of interfaces):
2
Type the default gateway address and proceed to step 3 above or type “0” 
to display the port table.
3
Enter the number of the port and press Enter. The default route is set and the 
Route Table is will be updated when the IAD is reset.
4
Continue with other configuration tasks, or press Escape to return to the 
Router Modification menu.
Remove Default Route
To remove a default route, follow the steps below.
1
On the Router Modification menu type “T” to select Remove the Default 
Route. The default route is immediately deleted and the Route Table is 
updated when the IAD is reset.
2
Continue with other configuration tasks, or press Escape to return to the 
Router Modification menu.
Display Route Table
Type “D” on the Router Modification menu to display the Route Table.
Enable/Disable RIP
When you enable RIP, the IAD sends routing data to adjacent routers and 
dynamically learns the associated network topology. To enable RIP globally, 
follow the steps below.
1
Type “R” on the Router Configuration menu (Figure 4.16), to select 
Enable/Disable RIP. The IAD displays the RIP current status and prompts 
you to enable or disable RIP globally.
2
Type “E” to enable RIP globally, or “D” to disable it globally. The IAD 
saves the configuration and displays the Router Configuration menu (Figure 
4.16
).