ZyXEL P-663H-51 Betriebsanweisung
Chapter 9 Quality of Service (QoS)
P-663H-51 User’s Guide
96
Rule Status
Select whether or not the classifier is to be active.
Assign
Classification
Queue
Classification
Queue
Select the QoS queue the ZyXEL Device uses for the packets of upstream traffic
that match this QoS classifier.
that match this QoS classifier.
Assign
Differentiated
Services Code
Point (DSCP) Mark
Differentiated
Services Code
Point (DSCP) Mark
Select the DSCP mark the ZyXEL Device assigns to the packets of upstream
traffic that match this QoS classifier.
traffic that match this QoS classifier.
Mark 802.1p if
802.1q is enabled
802.1q is enabled
Select the IEEE 802.1p mark the ZyXEL Device assigns to the packets of
upstream traffic that match this QoS classifier. This only applies when IEEE
802.1q is enabled. You enable IEEE 802.1q by enabling VLAN multiplexing in
the WAN screens (see
upstream traffic that match this QoS classifier. This only applies when IEEE
802.1q is enabled. You enable IEEE 802.1q by enabling VLAN multiplexing in
the WAN screens (see
Physical LAN Port
Select the source Ethernet port of the traffic.
Protocol
Select the type of packets.
Differentiated
Services Code
Point (DSCP)
Check
Services Code
Point (DSCP)
Check
Select the DSCP mark to check upstream traffic for.
IP Address/
Vendor Class ID
(DHCP Option 60)/
User class ID
(DHCP option 77)
Vendor Class ID
(DHCP Option 60)/
User class ID
(DHCP option 77)
Select whether to check for a source IP address, vendor class ID, or user class
ID. Then specify the source IP address, vendor class ID, or user class ID.
ID. Then specify the source IP address, vendor class ID, or user class ID.
Source Subnet
Mask
Mask
Specify the subnet mask of the device that sent the traffic.
UDP/TCP Source
Port (port or
port:port)
Port (port or
port:port)
This is the port number that a device used to send the traffic.
Destination IP
Address
Address
Specify the IP address of the device that the traffic is going to.
Destination Subnet
Mask
Mask
Specify the subnet mask of the device that the traffic is going to.
UDP/TCP
Destination Port
(port or port:port)
Destination Port
(port or port:port)
Specify the port number on a device to which the traffic is going.
Source MAC
Address
Address
Specify the MAC address of the device that sent the traffic.
Source MAC Mask
Specify the MAC address subnet mask of the device that sent the traffic.
Destination MAC
Address
Address
Specify the MAC address of the device that the traffic is going to.
Destination MAC
Mask
Mask
Specify the MAC address subnet mask of the device that the traffic is going to.
802.1p Priority
Specify the IEEE 802.1p mark on the traffic.
Save/Apply
Click this button to save the changes and have the ZyXEL Device start using
them.
them.
Table 38 QoS Class Configuration (continued)
LABEL
DESCRIPTION