ZyXEL 2WG Betriebsanweisung

Chapter 31 WAN and Dial Backup Setup

ZyWALL 2WG User’s Guide

The following table describes the fields in this screen.

The Dial Backup port can be used in reserve, as a traditional dial-up connection should the 
broadband connection to the WAN port fail. To set up the auxiliary port (Dial Backup) for use 
in the event that the regular WAN connection is dropped, first make sure you have set up the 
switch and port connection (see the Quick Start Guide), then configure 

1 Menu 2 - WAN Setup,
2 Menu 2.1 - Advanced WAN Setup and 
3 Menu 11.3 - Remote Node Profile (Backup ISP)

Refer also to the section

 

about traffic redirect for information on an alternate backup WAN 

connection.

From the main menu, enter 2 to open menu 2.

Table 199   MAC Address Cloning in WAN Setup

WAN 1 MAC 

Address

Assigned By

Press [SPACE BAR] and then [ENTER] to choose one of two methods to assign a 

MAC Address. Choose Factory Default to select the factory assigned default MAC 

Address. Choose IP address attached on LAN to use the MAC Address of that 

computer whose IP you give in the following field. 

IP Address

This field is applicable only if you choose the IP address attached on LAN method 

in the Assigned By field. Enter the IP address of the computer on the LAN whose 

MAC you are cloning.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to 

save your configuration, or press [ESC] at any time to cancel.