ZyXEL 2WG Betriebsanweisung
ZyWALL 2WG User’s Guide
579
C
H A P T E R
37
Remote Node Setup
This chapter shows you how to configure a remote node.
37.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.1 - Remote Node Profile, Menu 11.1.2 -
Remote Node Network Layer Options and Menu 11.1.4 - Remote Node Filter.
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.1 - Remote Node Profile, Menu 11.1.2 -
Remote Node Network Layer Options and Menu 11.1.4 - Remote Node Filter.
37.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown
below).
Enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your WAN
port. Enter 2 to open Menu 11.2 - Remote Node Profile (3G WAN) and configure the setup
for your 3G connection. Enter 3 to open Menu 11.3 Remote Node Profile (Backup ISP) and
configure the setup for your Dial Backup port connection (see
below).
Enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your WAN
port. Enter 2 to open Menu 11.2 - Remote Node Profile (3G WAN) and configure the setup
for your 3G connection. Enter 3 to open Menu 11.3 Remote Node Profile (Backup ISP) and
configure the setup for your Dial Backup port connection (see
).
Figure 366 Menu 11: Remote Node Setup
37.3 Remote Node Profile Setup
The following explains how to configure the remote node profile menu. Not all fields are
available on all models.
available on all models.
Menu 11 - Remote Node Setup
1. WAN_1 (ISP, SUA)
2. WAN_2 (ISP, SUA)
3. -Dial (BACKUP_ISP, SUA)
2. WAN_2 (ISP, SUA)
3. -Dial (BACKUP_ISP, SUA)
Enter Node # to Edit: