ZyXEL p-660h-61 Betriebsanweisung
Prestige 660H Series User’s Guide
34-8
Firmware and Configuration File Maintenance
3.
Press [ENTER] when prompted for a username.
4.
Enter your password as requested (the default is “1234”).
5.
Enter “bin” to set transfer mode to binary.
6.
Use “put” to transfer files from the computer to the Prestige, for example, “put firmware.bin ras”
transfers the firmware on your computer (firmware.bin) to the Prestige and renames it “ras”.
Similarly, “put config.rom rom-0” transfers the configuration file on your computer (config.rom)
to the Prestige and renames it “rom-0”. Likewise “get rom-0 config.rom” transfers the
configuration file on the Prestige to your computer and renames it “config.rom.” See earlier in this
chapter for more information on filename conventions.
Similarly, “put config.rom rom-0” transfers the configuration file on your computer (config.rom)
to the Prestige and renames it “rom-0”. Likewise “get rom-0 config.rom” transfers the
configuration file on the Prestige to your computer and renames it “config.rom.” See earlier in this
chapter for more information on filename conventions.
7.
Enter “quit” to exit the ftp prompt.
The Prestige automatically restarts after a successful file upload.
34.4.4 FTP Session Example of Firmware File Upload
Figure 34-7 FTP Session Example of Firmware File Upload
More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to section 34.2.5 to read about configurations that disallow TFTP and FTP over WAN.
34.4.5 TFTP File Upload
The Prestige also supports the uploading of firmware files using TFTP (Trivial File Transfer Protocol)
over LAN. Although TFTP should work over WAN as well, it is not recommended.
over LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware and the
configuration file, follow the procedure shown next.
configuration file, follow the procedure shown next.
1.
Use telnet from your computer to connect to the Prestige and log in. Because TFTP does not have
any security checks, the Prestige records the IP address of the telnet client and accepts TFTP
requests only from this address.
requests only from this address.
2.
Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System Maintenance.
3.
Enter the command “sys stdio 0” to disable the console timeout, so the TFTP transfer will not be
interrupted. Enter “command sys stdio 5” to restore the five-minute console timeout (default)
when the file transfer is complete.
when the file transfer is complete.
4.
Launch the TFTP client on your computer and connect to the Prestige. Set the transfer mode to
binary before starting data transfer.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit