ZyXEL p-660h-61 Betriebsanweisung
Prestige 660H Series User’s Guide
Remote Node Configuration
25-1
Chapter 25
Remote Node Configuration
This chapter covers remote node configuration.
25.1 Remote Node Setup Overview
This section describes the protocol-independent parameters for a remote node. A remote node is
required for placing calls to a remote gateway. A remote node represents both the remote gateway and
the network behind it across a WAN connection. When you use menu 4 to set up Internet access, you
are configuring one of the remote nodes.
required for placing calls to a remote gateway. A remote node represents both the remote gateway and
the network behind it across a WAN connection. When you use menu 4 to set up Internet access, you
are configuring one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that node’s
profile in menu 11.1, as well as configure specific settings in three submenus: edit IP and bridge
options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu 11.5.
profile in menu 11.1, as well as configure specific settings in three submenus: edit IP and bridge
options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu 11.5.
25.2 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
25.2.1 Remote Node Profile
To configure a remote node, follow these steps:
1.
From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
2.
When menu 11 appears, as shown in the following figure, type the number of the remote node that
you want to configure.