ZyXEL p-330w Betriebsanweisung

ZyXEL P-330W User’s Guide

27 

Chapter 2 Introducing the Web Configurator

1 Make sure the PWR LED is on (not blinking).

2 Press the RESET button for approximately ten seconds or until the PWR LED begins to 

blink and then release it. When the PWR LED begins to blink, the defaults have been 
restored and the P-330W restarts. (If you press the RESET button for less than 5 seconds, 
the P-330W will reboot, but will not reset the configuration).

The following summarizes how to navigate the web configurator from the SITE MAP screen.

• Click SETUP WIZARD for initial configuration including general setup, Wireless LAN 

Setup, ISP parameters for Internet Access and WAN IP/DNS Server/MAC address 
assignment.

• Click a link under WIRELESS to configure wireless settings.
• Click a link under ADVANCED to configure advanced P-330W features.
• Click LOGOUT at any time to exit the web configurator.
• Click ADMINISTRATOR to view information about your P-330W or upgrade 

configuration/firmware files. Administrator includes Statistics, Remote Management, 
Upgrade Firmware, Config File (Backup, Restore, Defaults) and Time Zone Settings.

Figure 3   The MAIN MENU Screen of the Web Configurator

After you log in, use the sub-menus on the navigation panel to configure P-330W features.