ZyXEL p-330w Betriebsanweisung

ZyXELP-330W User’s Guide

Chapter 3 Wizard Setup

36

Choose None to allow the WLAN to operate without encryption.  Warning: With no 
encryption enabled anyone will be able to access your network and view any data you send 
over the wireless LAN.

Choose WEP to setup WEP Encryption parameters.

Figure 10   Wizard 4: Wireless LAN Setup: WEP Security

The following table describes the labels in this screen.

Table 9   Wizard 4: Wireless LAN Setup: WEP Security

Key Length

Select 64-bit WEP or 128-bit WEP data encryption.

Key Format

Select ASCII in order to enter ASCII characters as the WEP keys. 
Select Hex to enter hexadecimal characters as the WEP keys.

Default Tx Key This key refers to which key below will be used as the default key.

Key 1 to Key 4  The WEP keys are used to encrypt data. Both the P-330W and the wireless stations 

must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal 

characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal 

characters   ("0-9", "A-F"). 
You must configure at least one key, only one key can be activated at any one time. 

The default key is key 1.