ZyXEL P-2602HW Benutzerhandbuch

Chapter 21 Bandwidth Management

P-2602H(W)(L)-DxA User’s Guide

The following table describes the labels in this screen. 

You must use the Bandwidth Management General screen to enable bandwidth 
management before you can configure rules.
Click Advanced > Bandwidth MGMT > Rule Setup to open the following screen.

Figure 171   Bandwidth Management: Rule Setup

The following table describes the labels in this screen.  

Table 121   Bandwidth Management: General

Active

Select the check box to enable bandwidth management. 

Auto 

Classifier

Select the check box to enable Automatic Traffic Classifier (ATC). ATC assigns each 

packet to a bandwidth management class based on its size, since time-sensitive 

applications such as VoIP tend to have smaller packet sizes than non-time sensitive 

applications such as FTP. When ATC is enabled, traffic with a smaller packet size is 

assigned a higher priority than traffic with a larger packet size. 

Apply

Click Apply to save your settings back to the ZyXEL Device.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 122   Bandwidth Management: Rule Setup

Direction 

Select LAN to apply bandwidth management to traffic that the ZyXEL Device 

forwards to the LAN. 
Select WAN to apply bandwidth management to traffic that the ZyXEL Device 

forwards to the WAN. 
Select WLAN to apply bandwidth management to traffic that the ZyXEL Device 

forwards to the WLAN. 

Service 

Select a service for your rule or you can select User define to go to the screen 

where you can define your own.

Priority

Select a priority from the drop down list box. Choose High, Mid or Low.