Sharp MX-M260 Benutzerhandbuch
135
7
STAPLE CARTRIDGE REPLACEMENT
(when the finisher (MX-FN13) is installed)
When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the procedure
below to replace the staple cartridge.
below to replace the staple cartridge.
Replacing the staple cartridge
1
Open the cover.
2
While pressing the lever over to the
left, slide the finisher to the left until it
stops.
left, slide the finisher to the left until it
stops.
Gently slide the finisher
until it stops.
until it stops.
3
Lower the staple case release lever
and remove the staple case.
and remove the staple case.
Pull the staple case out
to the right.
to the right.
4
Remove the empty staple cartridge
from the staple case.
from the staple case.
5
Insert a new staple cartridge into the
staple case as shown.
staple case as shown.
Push the staple cartridge
in until it clicks into place.
in until it clicks into place.
6
Replace the staple case.
Push the staple case in
until it clicks into place.
until it clicks into place.
7
Slide the finisher back to the right.
Gently slide the finisher
back to the right until it
locks into its original
position.
back to the right until it
locks into its original
position.
8
Close the cover.
Gently slide the finisher
back to the right until it
locks into its original
position.
back to the right until it
locks into its original
position.
Make a test print or copy in staple sort mode to verify that stapling takes place correctly.
Note
MX-M310.book 135 ページ 2009年7月6日 月曜日 午後6時57分