Amana aer5715qa Betriebsanweisung

Do not place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break
the door, or injure the user.

1. Do not use abrasive cleaning agents such as steel wool

scouring pads or powdered cleansers as they may scratch
the glass.

2. Do not hit the glass with pots, pans, furniture, toys, or other

objects.

3. Do not close the oven door until the oven racks are in place.

Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.

Note: The oven door on a new range may feel “spongy”
when it is closed. This is normal and will decrease with use.

LEVELING LEG

Be sure the anti-tip bracket secures one of the
rear leveling legs to the floor. This bracket pre-
vents the range from accidentally tipping.

Be sure the range is leveled when installed.  If
the range is not level, turn the leveling
legs, located at each corner of the
range, until range is level.

ANTI-TIP

BRACKET

• Disconnect power to range before replacing light bulb.
• Allow oven to cool before replacing light bulb.

• Make sure bulb cover and bulb are cool before touching.

Maintenance

The storage drawer can be removed to allow you to clean
under the range.

1. Empty drawer and pull out to the first stop position.

2. Lift up the front of the drawer.

3. Pull out to the second stop position.

4. Grasp sides and lift drawer up and out.

1. Fit the ends of the drawer glides into the rails in the range.

2. Lift up the front of the drawer and gently push in to the

first stop position.

3. Lift drawer up again and push until drawer is closed.

Do not store plastic, paper products, food or flammable
materials in this drawer. The drawer may become too warm
for these items when the oven is in use.

1. When oven is cool, hold bulb cover

in place, then slide wire retainer
off cover. NOTE: Bulb cover
will fall if not held in place
while removing wire retainer.

2. Remove bulb cover and light

bulb.

3. Replace with a 40-watt appliance bulb.

4. Replace bulb cover and secure with wire retainer.

5. Reconnect power to range. Reset clock.